D-Link NKJ-C6WHI1B21 Cat6 UTP RJ45 Keystone Jack, White

D-Link NKJ-C6WHI1B21 Cat6 UTP Keystone Jack

Find the D-Link Cat6 keystone jack price in BD on this page. The NKJ-C6WHI1B21 is an RJ45 socket that turns a permanent cable run into a clean, plug-in network point. Punch the cable into the back, clip the jack into a faceplate or patch panel, and connect devices with a patch cord.

Key features

• Category 6 unshielded (UTP) design for gigabit networks
• RJ45 8P8C socket with 50 micro-inch contact plating
• Punch-down termination of 4 pairs, 22–26 AWG
• 180° termination for easy access in faceplates
• Colour-coded labels for both T568A and T568B wiring
• Fits high-density keystone patch panels

Built for structured cabling

Keystone jacks are the standard building block of office cabling. Using the same D-Link Cat6 family for jacks, panels and patch cords keeps the system consistent and easier to certify and maintain.

Where to use it

Desk and wall outlets, ceiling points for Wi-Fi access points and cameras, modular patch panels in server racks, and floor boxes in meeting rooms.

Installation steps

1. Strip about 25mm of outer jacket.
2. Lay each pair into the slots following the colour labels for your chosen scheme.
3. Punch down with a 110-type tool and trim excess wire.
4. Fit the cap, snap the jack into the faceplate or panel, then test.

Tips

Keep pair twists right up to the termination, use the same wiring scheme throughout the building, and test each link with a cable tester after installation.

Buy from QASWATEC

QASWATEC supplies genuine D-Link cabling products. Visit our Elephant Road, Dhaka showroom or order online for delivery across Bangladesh.